Revolink Starlink Mini Magnetic Mount, Quick Release Mount with 3 rubber-coated magnets
Starlink Mini magnetic mount kit, rubber-coated magnets for Revolink Quick Release Mount
Scratch-safe rubber-coated mounting magnet with M6 threaded stem for Starlink Mini mount
Starlink Mini held in the Revolink magnetic mount, side view
Revolink Quick Release Mount with Starlink Mini installed, underside view
Revolink Quick Release Mount for Starlink Mini with cam-lever handles, top view
Starlink Mini on a magnetic mount on a red truck roof in the mountains
Starlink Mini Magnetic Mount – Quick Release Mount with Rubber-Coated Magnets
Starlink Mini Magnetic Mount – Quick Release Mount with Rubber-Coated Magnets
Three rubber-coated magnets with M6 threaded stems for Starlink Mini mount

Starlink Mini Magnetic Mount – Quick Release Mount with Rubber-Coated Magnets

Regular price$219.99
/
Shipping calculated at checkout.

Color
  • Free Shipping On Orders Over $199
  • 30 Day Return Policy
  • Low stock - 9 items left
  • Backordered, shipping soon

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.

The Revolink Starlink Mini Magnetic Mount pairs our Quick Release Mount with three rubber-coated magnets for a no-drill install on any flat steel roof, hood or panel. Swap the dish in and out in under 10 seconds, and lift the whole mount off when you're done.

Compatibility

  • Starlink Mini dish
  • Holds on flat steel, bare or painted: car and truck roofs, hoods, steel van and RV panels, steel trailer skins
  • Won't hold on aluminum, fiberglass, carbon or composite, including most truck caps, camper shells and Bronco hardtops

Quick test: if a fridge magnet won't stick, these won't either.

Driving While Installed: Hold depends on a flat, clean steel surface. Confirm all three magnets sit flat and pass a firm pull test before every drive. See the install guide for full instructions.

180 lb Combined Magnetic Hold

Each magnet is rated for 60 lb of pull force. Spaced in a triangle across the mount, the three give 180 lb of combined hold on flat steel.

Scratch-Safe Rubber Coating

A rubber jacket on each magnet protects painted finishes. Set the mount straight down, tilt it to remove, and keep both surfaces clean. Grit is what scratches paint.

Tool-Free Quick Release

Two cam-lever handles clamp the Starlink Mini between the end brackets. Flip them open and the dish lifts out in under 10 seconds, so you can take it inside or move it to another spot without touching the magnets.

Built for the Road

Powder-coated 5052 aluminum frame with stainless steel hardware. Foam-lined brackets hold the dish without rattling. Frame measures 12 × 8.5 × 2 in (305 × 218 × 53 mm).

5-Minute Setup

The magnets bolt through the mount's pre-punched holes with the included washers and M6 nuts. All you need is a 10 mm wrench.

What's Included

  • Revolink Quick Release Mount for Starlink Mini
  • 3 rubber-coated magnets, 60 lb pull each, M6 threaded stems
  • 3 washers and 3 M6 nuts

Need power? Add the Starlink Mini USB-C to Barrel Jack Power Cable or the USB Car Charger.

Revolink Satellite Gear is an independent accessory manufacturer, not affiliated with SpaceX or Starlink. Starlink Mini dish not included.